Uniden UDW10055 - Manual (Page 11)

11
Using the Menu
Item Use it to
Audio Vol
Adjust the volume of the audio from the camera. Choose a value from 0 (off)
through 20 (maximum).
Scan Time
Set the length of time the receiver spends on each active camera during a scan
(see page 16) or activate quad display (see page 17).
CAM1 – CAM4 Turn each of the four camera channels On (enabled) or Off (disabled).
Pair CAM Pair a camera to the selected channel (see page 14).
System Setup sub-menu
Brightness Adjust the brightness of the display. Choose a value from 1 (min) through 15
(max).
TV out Change the video output format from NTSC (North America) to PAL (Europe).
Power Save Turn on power save mode. If you set this field to Auto, the display turns off if it’s
idle for more than one minute. (The audio will remain active.) To turn the display
back on, press ok .
Factory Reset Reset the receiver to factory defaults. Any changes or settings will be lost.
OK
Audio Vol
Scan Time
CAM1
CAM2
CAM3
CAM4
Pair CAM
System
Factory
10
OFF
ON
ON
ON
ON
1 2 3 4
Setup
Reset
Brightness
TV out
Power Save
10
NTSC
OFF
OK
11 9
OK
To open the menu,
press
The selected
item is
highlighted
Use UP
and DOWN
to move
the cursor
Use LEFT
and RIGHT
to scroll
through the
options for
the item
To close the menu, press
To open the
System Setup
sub-menu, press