Uniden UDW10055 - Manual (Page 7)

7
Switch the bracket
If you want to mount the
camera in a hanging
position, you’ll need to flip
the bracket to the top of
the camera:
1. Remove the bolts
on the side of the
mounting bracket.
2. Carefully slide the
bracket off of the
camera and sun shield.
3. Rotate the bracket 180°
and slide it back onto
the camera.
4. If necessary, adjust the
camera angle, then
replace and tighten the bolts.
Mount the stand
1. Hold the base of the camera stand
where you want to mount it, and
mark the location of the screw
holes.
2. Use the included screws and
anchors to attach the base to the
wall or ceiling.
3. Before attaching the camera, tug
gently on the stand to make sure it
is securely in place.
1
2
3
Remove the bolts
and slide the mounting
bracket off of the camera.
Flip the bracket upside
down and slide it back
onto the camera.
Adjust the camera to
the desired angle
and replace and
tighten the bolts.