Uniden UDW10055 - Manual (Page 21)

21
If the static is only on 1 camera If the static is on all cameras
-Check near the camera for one of the common
interference sources.
-Try moving the camera away from a suspected
source, or try moving the suspected source so it’s
not between the camera and the receiver.
-Try moving closer to the receiver. There is always
more noise at the edges of the receiver’s range.
-Check near the receiver for the source of
interference.
-Try moving the receiver away from a
suspected source, or turn off the source if
possible.
-Try raising the receiver’s antenna so it
stands straight up.
Resetting Your System
Resetting the camera or receiver will erase any changes and set all values back to the default.
You should only reset your system under the following conditions:
Resetting the camera Resetting the receiver
-You are unable to pair the camera to the
receiver.
-The image on the screen is frozen.
-The buttons on the receiver are not responding.
-The image on the screen is frozen, and resetting
the camera did not help.
To reset the camera, unplug the AC adapter. Wait at least 15 seconds, then reconnect the AC
adapter.
To reset the receiver:
1. Unplug the AC adapter and make sure the power is off.
2. Extend the antenna and locate the hole for the reset button.
3. Insert a small object (like a pencil point or an unbent paper clip) into the hole and gently press
in.
4. Reconnect the AC adapter and let the battery charge fully.