Resetting the handset without the base, Changing the digital security code, Traveling out of range – Uniden DCT736 User Manual
Page 44: Changing.the.digital.security.code, Traveling.out.of.range, Resetting.the.handset.without.the.base
44
Resetting.the.Handset.without.the.Base
If.your.original.base.is.not.available.for.some.reason.(for.example,.it.is.
lost.or.somehow.incapacitated),.you.can.still.reset.the.handset.and.use.it.
with.another.base..
Press.and.hold.
[ ] and.[#/ ] for.at.least.5.seconds.until.the.
SYSTEM.RESET.menu.appears..
Move.the.cursor.to.select.the.REPLACING.BASE.submenu,.and.
then.press
..REPLACE.BASE.appears.
Move.the.cursor.to.select.YES,.and.then.press.
. A confirmation tone sounds. The handset de-
letes.its.own.base.information.without.trying.to.contact.the.base..When.the.base.information.is.deleted,.the.
handset.displays.MODELS.VARY!
CHARGE.HANDSET.ON.THE.BASE.REGISTRATION.OR.REFER.TO.
OWNER’S.MANUAL.
To.register.the.handset.to.the.new.base,.see.page.1.
Changing.the.Digital.Security.Code
The digital security code is an identification code used to connect the handset and the base unit. Your unit ships from
the.manufacturer.with.a.preset.security.code..Resetting.this.code.is.not.normally.necessary..In.the.rare.situation.that.
you.suspect.another.cordless.telephone.is.using.the.same.security.code.or.if.you.are.instructed.to.change.this.code.
by.a.manufacturer’s.Call.Center.Representative,.you.can.change.the.code..To.change.the.digital.security.code:
Reset.all.handsets.(see.page.).
Re-register.each.handset.by.following.the.steps.on.page.1.
Traveling.Out.of.Range
During.a.call,.as.you.begin.to.move.your.handset.too.far.from.your.base.unit,.noise.may.increase..If.you.pass.the.
range.limits.of.the.base.unit,.you.hear.a.beep.and.see.OUT.OF.RANGE.on.the.display,.and.then.the.handset.returns.
to.standby..You.may.return.to.the.call.if.you.move.your.handset.within.the.range.limits.of.the.base.and.press.
[ /flash] or.[ ].within.30.seconds.
1.
.
3.
1.
.