Uniden UBC30XLT - Manual (Page 14)

14
Setting Up Your Scanner
Setting Up Your Scanner
These guidelines will help you install and use your
new scanner:
• If your scanner receives interference or electrical
noise, move the scanner or its antenna away
from the source.
• To improve the scanner’s reception, use an
optional external antenna designed for multi-
band coverage. (You can purchase this type of
antenna at a local electronics store). If the
optional antenna has no cable, use 50-70 ohm
coaxial cable for lead-in. A mating plug might be
necessary for the optional antennas.
• Use an optional mono earphone or mono
headset with proper impedance for private
listening. Read the precautions on the inside
front cover of this Owners Manual.
• Do not use the scanner in high-moisture
environments such as the kitchen or bathroom.
• Avoid placing the scanner in direct sunlight or
near heating elements or vents.
Installing and Replacing Batteries
You can power your scanner using three AA alkaline
batteries.
1. Make sure the power is turned off.
2. If the belt clip is attached, remove it (See
page 18).
3. Slide the battery compartment cover.
UB333 Paper OM reduced size.fm Page 14 Friday, June 3, 2005 1:43 PM