Uniden UBC30XLT - Manual (Page 33)

33
Troubleshooting
Resetting the Scanner
If the scanner's display locks up or stops operating
properly, you might need to reset the scanner.
Caution: This procedure clears all the information
(except the band plan data) you have stored in the
scanner. Before you reset the scanner, try turning it
off and on to see if it begins working properly. Reset
the scanner only when you are sure it is not working
properly.
1. Turn off the scanner.
2. While holding down and , turn on the
scanner. It takes about 3 seconds to initialize
and CLEAr appears.
Scan
won’t stop
(continued) The channel
might not be
active. Wait for a
transmission on the
channel.
Scan
won’t
start. You must
press RSM/
HOLD to scan. Press RSM/HOLD.
The squelch
might need to
be adjusted. Adjust the squelch
threshold. See
“Turning On The
Scanner and
Setting Squelch” on
Page 25.
One or more
channels might
be locked out. Make sure the
channels you want
to scan are not
locked out.
The antenna
might need to
be adjusted. Check the antenna
connection.
UB333 Paper OM reduced size.fm Page 33 Friday, June 3, 2005 1:43 PM