Uniden UBC30XLT - Manual (Page 25)

25
Operation
Operation
Turning On The Scanner and
Setting Squelch
Note: Make sure the scanner's antenna is
connected before you turn it on.
1. Press and hold PWR for 2 seconds. The scanner
turns On.
2. Press VOL/SQ. SQ appears with the current
setting.
3. Repeatedly press or to select the squelch
level you want.
Squelch is fully open at level 0, and most tight at
level 10.
Note: Squelch can be adjusted both in Frequency
Mode and Memory Mode.
Adjusting the Volume Level
1. Repeatedly press VOL/SQ until VOL appears.
2. Use or to select the volume level you prefer
from 30 levels.
3. Press PWR or wait for 2 seconds to return to the
mode you were in.
Note: Volume level can be adjusted both in
Frequency Mode and in Memory Mode.
Frequency Search Mode
Changing the Step of Frequency
You can change the steps of each band.
1. Press FNC + STEP until a band you want to
change appears.
2. Use or to select steps from Auto, 5kHz,
6.25kHz, 8.33kHz, 10kHz, 12.5kHz, 15kHz,
20kHz, 25kHz, 50kHz and 100kHz.
UB333 Paper OM reduced size.fm Page 25 Friday, June 3, 2005 1:43 PM