Uniden UBCT9 - Manual (Page 50)

4
9. Use the keypad to enter a new Offset Channel, then press E.
Note: • You can only input within a range of 380-759.
• If the system is not tracking properly, you may need to
try a new Base Frequency or Offset Channel, or you
may be missing frequencies from the system.
• You can set up to three Base, Spacing and Offsets for Motorola VHF/UHF trunked
systems.
Toggling the Status Bit
On Type II trunking systems there is a method by which specialized types of
communications utilize unique talkgroup numbers. An emergency call will occur on a
unique talkgroup from its primary assignment, for example. Because the UBCT9 defaults
to Status-Bit ON mode, you never need to worry about missing these transmissions. If you
have programmed talkgroup 33264 into Scan List memory, for example, and there is an
emergency call within the group, you will hear it on 33264.
The only time you may wish to turn Status Bits OFF is if you’re trying to figure out the
proper Fleet Map of a Type I trunking system.
1. Press and hold TRUNK for 1.5 seconds and select the bank you want to change.
2. Use the or key to select
(Motorola TYPE2 800MHz) , (Motorola Type2
VHF) or (Motorola Type2 UHF), then press E.
3. Use the or key to select , then press E.
4. Use the or key to select or , then press E. The scanner returns to
Status Bit list item.
Control Channel Only Mode
When this function is activated, trunking is performed using Control Channel data only.
Voice channel (also known as “DATA channel”) frequencies do not have to be programmed
into memory. This feature only applies to Motorola 800 MHz systems.
1. Press and hold TRUNK for 1.5 seconds and select the bank you want to change.
2. Use the or key to select (Motorola Type2 800MHz) or (Motorola Type1
800 MHz), then press E.
3. Use the or key to select , then press E.
4. Use the or key to select a plan from 2 frequency plans,
then press E. The scanner returns to Control Channel Only
list item.
Note: Y ou must choose a plan before you begin to Control Channel Trunk (Only when 800
MHz system is selected).
When you deselect Control Channel only mode, appears on the display.
UBCT9 OM 46 12/11/07 3:54:00 PM