Uniden UBCT8 - Manual (Page 24)

Set Close Call Alert
This option controls whether the scanner sounds an additional
alert tone when a Close Call signal is detected.
Press or to select the option, and then press E.
Setting of pager screen
Alert Tone Volume
Alert Light Adjustment
This option sets whether the scanner screens common pager frequencies from hits during
Close Call searching.
1. Press or , to select the option, and then press E.
Pager Screen On : The scanner ignores hits on common pager frequencies.
Pager Screen OFF : The scanner does not screen for common pager frequencies.
Pager screen affects the following frequency range.
148.0000 - 149.2500 MHz
2. To return to previous mode, press
Push to select Loud, Medium, or Soft.
The Alert Tone beeps and the alert light flashes to
confirm your choice.
The Alert Light has three settings (Bright, Dimmer, Off).
Push to select Bright, Dimmer or Off.
The Alert Light flashes and the alert tone beeps.
If you select Off, will be displayed to
remind you the Alert Light is Off.
Note:
VOL
SQL
“FLASH”
!
!