Uniden UBCT8 User Manual
Page 40
ID Lockout
Review ID Lockout
Restoring Locked-out IDs
Like conventional scanning, it’s possible to lockout unwanted traffic. This is particularly
important in trunked systems because in many areas, water meters, door alarms, traffic
signals, and other mechanical devices are assigned IDs just like other users. Also some
departments scramble or encrust their communications, and you may want to lock out these
unintelligible broadcasts.
To Lockout an ID, press
on the ID you want to lockout.
The ID is locked out. You can Lockout up to 100 IDs.
If you Lockout an ID in Search mode, it is also locked out in Scan List mode.
Conversely, if you Lockout an ID while in Scan List mode, it is locked out in Search
mode. For information about Scan Lists see page 31.
is a powerful form of ID Lockout that can be used only with AFS and
EDACS systems. This feature lets you lockout entire Agencies or Fleets, not just individual
talkgroups. Using EDACS Blockout you can, for example, prevent Search from stopping on
any of hundreds of talkgroups in the Utilities agency. You can do this with just a few key
presses. To use this mode just enter the Agency-part, or the Agency-Fleet part, of the
talkgroup code and press
. For example, to Blockout Agency 4 in Trunk Search, press
, , ,
(decimal key), and then
. For other ways to use partial AFS
entry, be sure to read the section "EDACS Reception".
You can check all IDs already locked out.
1. Press and hold
for 1.5 seconds in the Trunking mode.
2. Select the bank you want to review by using the keypad, and then the trunked system
selected appears on the display. Then press .
3. Select
by using the
or
key ,and then press .
4. You can see the locked out IDs by using the
or
key.
Press and hold
for 2 seconds to check all locked out IDs when in the Trunking
mode.
•
While in locked out review mode, select the locked out ID you want to restore and press
.
To restore all locked out IDs in a bank once:
•
While in locked out review mode, press and hold
for 3 seconds. All locked out IDs in
a bank are restored.
L/O
Note:
EDACS BLOCKOUT
L/O
HOLD/RESUME 0 4
L/O
TRUNK
E
E
Hint:
L/O
To restore a single ID, follow these steps:
L/O
The ID is restored and “L/O” disappears.
L/O
An Error message ("Full") is
displayed when you try to register the 101st lockout.