Uniden UBCT8 - Manual (Page 25)

SCAN
SCAN
SCAN
Private Bank Scanning
Programming Frequencies into Channels
Deleting a Stored Frequency
Before the scanner begins Private Bank scanning, you must program a frequency into at
least one channel.
You will need to program each frequency into the scanner’s channels in order to hear these
frequencies.
1. Press and enter the channel
number where you want to store a frequency by
using the keypad, then press
. Change the channel by using the or key.
2. Enter the frequency you want to store by using the
keypad and (decimal key).
3. Press to store the frequency into the channel.
4. If you want to program another frequencies into the
channel, select another channel by using the or
key.
To clear a mistake while entering the frequency, press (decimal key)
repeatedly until the display is cleared.
• If you enter a invalid frequency, an error tone will sound and appears on
the display. To clear the Error message immediately, press (decimal key).
• Even if you don't enter full numbers as a frequency number, the scanner will
automatically select the nearest valid frequency.
To delete a stored frequency:
a. Select a channel.
b. Press .
c. Then press .
Channels with no frequencies are automatically locked out.
HOLD/RESUME
HOLD/RESUME.
E
Note: •
"Error"
0
E
Note:
Visit our website (www.uniden.com.au, www.uniden.co.nz) for
information on known frequencies.