UMAX Technologies Mirage II - Manual (Page 14)

7
Chapter 2: Macintosh Installation
This chapter describes how you can use your scanner with your Macintosh computer.
Connecting Scanner to your Computer
1. Ensure that the scanner’s SCSI ID is properly set. Refer to the “Change the SCSI
Number” section in Chapter 1 for instructions on setting the scanner’s SCSI ID.
2. Connect the SCSI cable to your Macintosh’s SCSI port and connect the other
end of the SCSI cable to the scanner.
Note: If your scanner is not chained to other SCSI devices and is the last device,
please connect the terminator to the remaining SCSI port of your scanner.
3. Connect the power cord to the scanner. And connect the other end of the power
cord to a grounded power socket.
4. Turn on the scanner power.
5. Turn on the computer power .
Installing the Software
Install the software in the following order:
1. Image Application Software, e.g. binuscan PhotoPerfect, Adobe Photoshop.
2. Then, Your scanner driver.
Scanner driver is the interface used by application software to control scanners. Its
advanced controls allow precise adjustments in images even during the initial scan.
For detailed information on installing the software, refer to the Installation section of
the Image Application Software User’s Guide and MagicScan Electronic Books.