Uniden GNS8435 - Manual (Page 63)

35
Tip: If you want to see the map around the Cursor, close the Cursor menu and reopen
it. When this menu is opened manually, the map is always moved to have the cursor
in the centre.
The content of the Cursor menu depends on the screen (Map or Cockpit) and it is
slightly different if there is an active route already planned. You have the following
options:
• Start: use the Cursor as the departure point for your route. This menu point is
available only in Map mode and when there is no active route. In Cockpit mode
the departure point of the route is always the GPS position or if it is not available,
the last known GPS position.
• Route To: use the Cursor as the destination of your route. This button is to start a
new route. The previous route (if it exists) will be deleted and replaced. If a
multi-point route is active, Uniden Navigation will ask you whether you really want
to delete it together with all its via points.
• Add Via: by inserting the selected map point as a via, you instruct Uniden
Navigation to cross this location before the destination of the route. This is the
way to build a multi-point route in reverse order (when you wish to insert a
stopover ‘go to A but first get some fuel at B’ or want to influence the direction of
the route). This menu point works only if a route is already active.
• Remove Via: removes the ‘via point’ near or at the Cursor. The route will be
recalculated immediately excluding the deleted point. This menu point replaces
Add Via and is available only if the Cursor is near or at a via point.
• Continue: add a new destination to be reached after the previous destination.
The new destination replaces the old one, which is now demoted to a via point.
This is the way to build your multi-point route in straight order (when you wish to
visit several destinations ‘go to A then to B’). This menu point is available only if a
route is already active.
• Add Cam: this button will place a speed camera at the position of the Cursor. A
new window opens where you can set the type of the camera (fixed, mobile,
built-in, or section control camera), the direction of the monitored traffic (your
direction, the opposite direction, both directions or all directions), and the speed
limit. If the map contains speed limit information, this will be the default value for
Camera Speed.