Uniden 2305 - Manual (Page 4)

[ 3 ]
1 Press down on the battery cover
release and slide the cover down
until it comes off.
2 Plug the battery pack connector
(red & black wires) into the jack
inside the battery compartment.
(The connector notches fit into the
grooves of the jack only one-way.)
Match the wire colors to the
polarity label in the battery
compartment, and push the
connector in until you hear a click.
Red
Wire
Black
Wire
Installing the Battery Pack
1 Connect the AC adapter
to the DC IN 9V jack
and to a standard AC
wall outlet.
2 Set the charger on a
desk or tabletop, and
place the handset in
the charger with the
keypad facing forward.
Connect the Charger
• Use only the supplied AC adapter. Do not use any other
AC adapter.
• Place the charger close to the AC outlet so that you can
unplug the AC adapter easily.
3 Make sure the charge LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in
and that the handset makes good contact with the charger
charging contacts.
To AC outlet
AC adaptor
(supplied)
To DC IN 9V
UU881BH(WDECT2305) ENG 5/10/04 3:57 PM Page 3