Uniden Waterproof DSC Marine Radio UM380 - Manual (Page 14)

10 English
Using the radio in scan mode
x
You cannot transmit while in scan mode.
x
You must have two or more channels in memory to start a scan.
x
To save a channel into memory, select the channel, then press and hold WX-MEM for two
seconds. Memory will show on the display.
x
To remove a channel from memory, set the radio to that channel, then press and hold WX-
MEM for two seconds. Memory will no longer show on the display.
x
To activate scan mode, press and hold CLR-SCAN . Press and hold CLR-SCAN again to return
to the previous mode.
x
When the radio automatically stops on a channel, press CHANNEL UP to leave that channel
and resume scanning.
x
To end the scan, press the microphone’s PUSH TO TALK, CALL-MEM, or WX-MEM buttons. The
radio remains on the last scanned channel.
Scan mode with Weather Alert Watch
If you activate Weather Alert Watch while operating in scan mode, the radio checks the most
recently-used weather channel
every seven seconds, then
continues scanning the next
channel in memory.
To turn Weather Alert Watch on
or off, press and hold CALL-MENU
while the radio is idle. Select
Setup and then WX Alert Mode.
Use CHANNEL UP and CHANNEL
DOWN to choose WX Alert Mode
setting ON or Off.
Scan mode with Triple and Dual Watch
If you activate Triple Watch while operating in scan mode, the radio checks channels 16 and
9 every two seconds, then goes on
to scan the next channel; with
Dual Watch turned on, the radio
only checks channel 16.
Press and hold
16/9-TRI on the
radio for two seconds to turn
Triple/Dual Watch on or off. (To
change between Triple or Dual
Watch, see page 14.)
Press and hold the
CLR-SCAN key to turn off Scan mode and set the radio to Triple/Dual Watch
mode.
09 16
Triple Watch : Every 2
seconds, the radio checks
channels 9 & 16 then goes on
to the next channel.
Memory Channel Scan
08 25 24 17 15 14 13 12 11 10 20
UM380_20101221.indd 10 4/13/2011 11:25:09 AM