Uniden UBC396T - Manual (Page 63)

61
Programming Radio Systems
Programming Conventional
Systems
Program System
New System
Conventional
Confirm? Yes=”E” / No=”.”
The scanner creates an empty conventional system,
with a default name of System n C.
n
is a number that increments as you add new
systems. C indicates that this is a conventional system.
Refer to the appropriate section to set system-wide
options:
• See "Editing the System Name" on Page 74
• See “Editing the System Quick Key” on Page 75
• See “Setting System Lockout” on Page 75
• See “Setting the System Hold Time” on Page 76
• See “Setting the Channel Delay Time” on Page 76
• See “Deleting Systems” on Page 83
• See “Copying Systems” on Page 83
• See “Entering/Editing Conventional Channel
Groups” on Page 61
Entering/Editing Conventional
Channel Groups
To enter channels in a conventional system, first set up
a channel group (or groups) to hold the channels. Then,
enter the channel and channel parameters in the group(s).
Setting Up a Channel Group
Program System
Select the system
Edit Group
New Group
Menu
Menu