Vanguard Managed Solutions Vanguard 6500 PLUS - Manual (Page 23)

About the 6500
PLUS
1-15
Hardware
6500 PLUS Token Ring Interface Module Option
Introduction The Token Ring Interface Module (TRIM) card is an option card that lets you route
LAN traffic through your network.
Features The TRIM card provides the following features:
• VanguardMS Periphery Routing
• One Token Ring LAN port operating over Shielded Twisted Pair (STP) or
Unshielded Twisted Pair (UTP) cable at 16 or 4 Mbps
• IBM-compatible Source Route Bridging support
• Support for up to 32 remote LAN bridge connections
• Capability for Frame Relay, X.25, MX.25, and/or XDLC network connections
for Token Ring LAN traffic
Description You can mount the TRIM card on 6507 PLUS or 6525 PLUS processor cards (not
6505 PLUS cards) within a Modulus enclosure. The TRIM card is suitable only in a
Modulus enclosure. A single node can support just one TRIM card. Modulus 8 and
Modulus 9 enclosures can support one node containing a TRIM card. Modulus 18
and Modulus 21 enclosures can support a maximum of three nodes containing
TRIM cards.
The TRIM card provides one LAN port through its backplane; connection can be
made through either the unshielded twisted pair (UTP) or the shielded twisted pair
(STP) LAN connectors. All LAN configuration is performed through Control
Terminal Port (CTP) menus. See the Vanguard ONS Basics Protocols Manual
(T0106) for configuration information.
A PROM chip on the TRIM card provides the BIA (Burned In Address), the LAN
MAC address unique to that port. The BIA is the default value for the Port TMAC
Address (found in the Port configuration record).
TRIM Card Figure 1-6 shows how the TRIM card is mounted on the processor card.
Figure 1-6. Token Ring Interface Module (TRIM) Card
TRIM Card
Processor Plus Board
(Solder Side)
Bottom of Card