Vivotek FD7131 - Manual (Page 62)

- 61 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Restoring the factory defaults will erase any previous settings. Reset or
restore the system after power on.
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition LED color
Loading system after power on Blink green and orange (twice)
During booting procedure Non light
Detecting and setting network Steady orange till IP address is confirmed
After network is setup (system up) Blink orange and red
During the upgrade firmware process Rapidly blink orange till firmware is
upgraded
Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or
restore the factory default settings. Sometimes resetting the system sets the system
back to normal state. If the system problems remain after reset, restore the factory
settings and install again.
RESET: Click on the button.
RESTORE:
1. Press on the reset button continuously until the status LED
rapidly blinks orange. It takes about 30 seconds.
2. Upon successful restore, the status LED will blink orange and red.