Vizio XVT472SV - Manual (Page 40)

VIZIO XVT472SV User Manual
40
www.VIZIO.com
Reset Picture Mode
Return all Picture settings to factory default. A screen will come up to confirm your selection or to cancel it.
Press either ◄ or ► to make the selection, and then press OK to accept it.
Note: Only settings under the Picture menu will be reset.
Audio Menu
1. Press MENU on the remote control and the Picture menu will be shown on the screen.
2. Press ▲ or ▼ on the remote control to highlight the Audio menu, and then press OK to select it.
3. Press ▲ or ▼ on the remote control to select an Audio menu option.
4. Once the menu option is highlighted, press ◄ or ► on the remote control to adjust the setting.
5. Press
MENU once to return to the previous screen or repeatedly to return to your program if the task
has been completed.
Audio Mode
Choose from Flat, Rock, Pop, Classic or Jazz.
Equalizer
To select the options in the Equalizer sub-menu,
press OK. A new menu will be displayed showing
the volumes of different frequencies.
Starting from lowest to the highest, they are 120 Hz,
500Hz, 1.5 kHz, 5 kHz and 10 kHz.
1. Press ◄ or ► to select the frequency to be
adjusted.
2. Use ▲ or ▼ to adjust to adjust the selected
frequency to your preference. Values above
0 will boost the frequency and values below
0 will attenuate the frequency.
Note:
The Equalizer adjustment will only be available when SRS TSHD is set to Off.
Balance
Adjust the sound to the left or the right.
SRS TruSurround HD (TSHD)
When watching TV or a movie, TruSurround HD™ creates an immersive surround sound experience from
only two speakers and provides rich bass, clear dialog and high frequency detail.
Note: When SRS TSHD is ON, Equalizer adjustments are not available.
SRS TruVolume
When the programming switches to a commercial or when changing from channel to channel, volume
fluctuations occur. When turned on, TruVolume™ provides the listener with a comfortable and consistent
volume level.
Digital Audio Out
This option allows selection of the type of processing for the SPDIF (Optical connector) when used with a
Receiver/Amplifier/Home Theater system. Select to choose from OFF, Dolby Digital or PCM.
Note: Dolby Digital 5.1 is only available when the input is TV, and the station is broadcasting in 5.1. The
TV does not pass through Dolby Digital 5.1 from HDMI.