VTech DS3111-3 - Manual (Page 5)

www.vtechphones.com 2
• Use only the
VTech batteries
and power
adapters supplied
with this telephone.
To obtain a
replacement, visit
our website at
www.vtechphones.
com or call
1 (800) 595-9511.
In Canada, go to
www.vtechcanada.
com or call
1 (800) 267-7377.
• The power
adapters are
intended to be
correctly oriented
in a vertical or floor
mount position.
The prongs are not
designed to hold
the plug in place
if it is plugged into
a ceiling or an
under-the-table/
cabinet outlet.
Installation
Telephone base & charger installation
We recommend that you install the telephone base away from any electronic
equipment and appliances such as personal computers, computer routers,
television sets, microwave ovens, and refrigerators. Avoid excessive heat, cold,
dust or moisture. When a location is selected, install the telephone base and the
charger as shown below. The telephone base is designed for desk or tabletop use
only. Make sure that the electrical outlet is not controlled by a wall switch.
Telephone
wall jack
Electrical outlet
not controlled by
a wall switch
Telephone base power adapter
Charger adapter
Telephone line cord
MANUFA CTURED IN CHINA COMPLIES WITH 47 CFR PA RT 68 REGISTRATION NO.: US:EW7W401B80-565600 RINGER EQUIVA LENCE: 0.1B USOC JACK: RJ11C/RJ1 1W HAC FCC ID: EW780-5656-00
THIS DEVICE COMPLIES WITH PA RT 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE; AND 2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERAT ION. PRIVA CY OF COMMUNICAT IONS MAY NOT BE ENSURED WHEN USING THIS PHONE.
DC 6V 300mA CLASS 2 POWER SOURCE ONLY
TELEPHONE
EQUIPMENT
DSL filter (not
included) required
if you have DSL
high-speed
Internet service