Veo ICA-500 - Manual (Page 25)

ICA-500 User’s Manual
25/80
Network
: Configure Network setting such as DHCP On/Off, DDNS and
PPPoE
DHCP:
DHCP: Stands for Dynamic Host Configuration Protocol.
“DHCP ON” is default network setting of the ICA-500, when a ICA-500 is joined into the
LAN, it will issue the DHCP packets to request an IP address that is dynamically
assigned by the DHCP server. If it can not get a DHCP address on a limited tries, the
ICA-500 will assigned a default IP address as the default IP address.
IP address, Subnet mask, Default gateway, Primary DNS, Secondary DNS:
If you turn DHCP OFF, then you need to enter those network parameters by yourself.
Note: User need to reboot the ICA-500 to make this setting to take effect.
HTTP Port 1:
Users could assign the port number of http protocol, and the WAN users should follow
the port number to login. If the http port1 is not assigned as 80, users have to add the
port number in back of IP address. For example:
http://192.168.0.20:12000 . If the http
port1 is assigned as 80, users do not have to add the port number in the back of IP