Velodyne Acoustics Digital Drive Subwoofer - Manual (Page 13)

Velodyne Digital Drive User’s Manual Page 8
Figure 3: Introductory Screen
See Figure 3. This the Introductory screen. Notice that as you change settings (such as preset,
volume, etc.) this is shown on this screen.
You enter setup mode by pressing MENU and entering the code 12345. Upon successful entry of this
code, the system takes you to the EQ Setup screen, as shown in Figure 4.
Onscreen Programming and Setup – Overview
You are now ready to set up and adjust the onscreen audio settings of your Digital Drive subwoofer.
This section provides an overview of the setup process. You will be doing all setup functions with the
buttons of your Velodyne-supplied remote control and seeing the results on your TV screen. Words in
all uppercase letters in the setup instructions (e.g., SELECT, MENU, etc.) identify the specific remote
button to be pressed or selected, or the field on the screen you should be paying attention to. Remem-
ber to point the remote control at the subwoofer, not your TV!
Use the RIGHT and LEFT directional arrow buttons that surround SELECT to move through the fields
of the setup screen, and change settings by using the UP and DOWN arrow keys. A screen field
highlighted in reverse video indicates your current location on the screen. Holding down the LEFT or
RIGHT arrow key causes the remote to repeat and you can then rapidly move through fields to arrive at
the desired one. You should be able to perform most of the setup process by using the four arrow keys
and the SELECT button.
Following is an overview of the screens you will be using to set up your Velodyne Digital Drive subwoofer.