Velodyne Acoustics Digital Drive Subwoofer - Manual (Page 32)

Velodyne Digital Drive User’s Manual Page 27
APPENDIX A: RS-232 Serial Overview and Commands
Introduction
This document outlines Velodyne’s Digital Drive (DD) RS-232 protocol specification. This protocol
indicates how Velodyne 1812 and Digital Drive products receive run-time commands from devices
such as Creston Universal Remote Controls.
Com Port Setup
Use standard communications settings: Baud Rate: 9600, Data Bits: 8, Parity: None, Stop Bits: 1
DD IN and OUT Port Pin Configuration
DD serial ports use a standard configuration that allows direct connection to a PC via a FEMALE to
MALE serial cable. It uses only 3 pins (Transmit, Receive, Ground). The pin configurations are:
IN: Pin 2 = Transmit
Pin 3 = Receive
Pin 5 = Ground
OUT: Pin 2 = Receive
Pin 3 = Transmit
Pin 5 = Ground
Runtime Command Format
Byte Number Byte Description Notes
0 ‘#’ Header Character
1 to 3 or 4 Command and Parameter Data 3 to 4 ASCII characters, see formats on next page.
Case sensitive - CAPS ONLY!
4 or 5 ‘$’ Termination Character (required or command is
ignored)
(continued next page)