Velodyne Acoustics Digital Drive Subwoofer - Manual (Page 21)

Velodyne Digital Drive User’s Manual Page 16
You are now ready to adjust the crossover, subsonic filter, volume, and phase controls of your DD unit.
NOTE: If the remote seems intermittent or unresponsive, be sure you are pointing it at the subwoofer
and not your TV!
AND REMEMBER: Use the RIGHT and LEFT directional arrow buttons that surround SELECT to
move through the fields of the setup screen, and change settings by using the UP and DOWN arrow
keys.
14. Beginning with the low pass crossover, set the frequency to the same value as the crossover
settings on your receiver/processor (for example, many units have a large/small satellite setting).
Again, consult your owner’s manual for more information. You will notice that changing these
values “cascades” the values out to all the presets. That is because once these values are set,
they will not normally change from preset to preset, but if later you wish to customize a specific
preset you can. Remember to use the LEFT and RIGHT arrow buttons for navigation on this
screen, and the UP and DOWN buttons for changing the values. An example of a crossover
changed to 100Hz is shown on the next page.