VTech ia5829 - Manual (Page 11)

8
Getting Star
ted
Setup
Set Date and Time
If you subscribe to caller ID service, the date and time will be set automatically with
the first incoming call. If you do not have caller ID service, you can set the date and
time manually:
• Press PROG on the handset.
• Press or until DATE/TIME is displayed. Press SELECT.
• The month is flashing. Press or until the screen displays the correct
month. Press SELECT.
• The day is flashing. Press or until the screen displays the correct
day. Press SELECT.
• The hour is flashing. Press or until the screen displays the correct
hour. Press SELECT.
• The minute is flashing. Press or until the screen displays the correct
minute. Press SELECT.
• AM or PM is flashing. Press or to choose between AM or PM.
Press SELECT.
Wall Mounting
The wall mount bracket is designed for use on standard wall mount plates only.
1. Run the power and telephone line cords through the slots in the bracket,
connecting them to the jacks located on the underside of the base.
2. Plug the AC adapter into an electrical outlet. If the battery has not been
previously charged, place the handset in the base, and allow it to charge for 10-
12 hours (or overnight).
3. Connect the telephone line cord to the wall jack.
4. Line up the tabs on the
wall mount bracket with the
slots on the bottom of the
base unit. Snap the bracket
firmly in place.
5. Mount the base on the
wall. Position the base unit
so the mounting studs will
fit into the holes on the wall
mount bracket. Slide the
base unit down on the
mounting studs until it locks
into place.
Check for Dial Tone
After the battery is charged, pick up the handset and press PHONE/FLASH. You should
hear a dial tone.