VTech ia5829 - Manual (Page 9)

6
Getting Star
ted
Setup
Installation and Charge of Battery
1. Install the battery. Use only VTech batteries.
a) Remove battery
compartment cover
by pressing on the
indentation and sliding
downward.
b) Align the two holes in the plug with the
socket pins, then snap the plug into place.
c ) Place the battery in the compartment
with the wires in the lower right corner.
d) Replace the battery compartment cover.
e) If the battery is not already charged,
place the handset in its base and allow
to charge for 10 - 12 hours (or over-
night). After that, be sure to place the
handset in its base when not in use to
ensure maximum daily performance.
Connecting Power to Base Unit
2. Plug the DC connector to the base.
Plug the AC adaptor into an electri-
cal outlet.
Connect the
p o w e r c o r d
Standard electrical outlet
1. Choose a location for the base
near an electrical outlet and a tele-
phone jack. This phone requires
a modular telephone jack and a
standard electrical outlet (110V
AC) not controlled by a wall
switch.