Vivotek IP7152 - Manual (Page 65)

- 64 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Restoring the factory
defaults will erase any previous
settings. Reset or restore the
system after power on.
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition LED color
Loading system after power on Steady green and blink red (once)
During booting procedure Blinking red
Detecting and setting network Steady green till IP address is confirmed
After network is setup (system up) Blinking green every other second and
steady red
During the upgrade firmware process Blink green / orange every second and fast
blink red
Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or
restore the factory default settings. Sometimes resetting the system sets the system
back to normal state. If the system problems remain after reset, restore the factory
settings and install again.
RESET: Click on the button.
RESTORE:
1. Press on the button continuously.
2. Wait for self-diagnostic to run twice.
3. Free the button as soon as the second self-diagnostic starts.