VBrick Systems ETHERNETV V4.4.3 - Manual (Page 176)

164 © 2009 VBrick Systems, Inc.
3. On the following window, select
Enable
and click
Next
, then
OK
to exit. This will enable
the machine as a warm backup. This will complete the configuration and there is no need
to reboot the server.
4. When finished, launch ETV Backup using the desktop icon.
6. Test the Configuration
When you are finished configuring the IP addresses, click the
Run
icon in the navigation
footer. All backup profiles should run without errors and a window similar to the one shown
below will report a successful backup for each profile. If problems occur, for example if you
entered an invalid IP address, the window will report any failures. Correct the problems using
the information provided in the log window and try again.
T To test the configuration:
1. Highlight the MCS Warm Backup Group and click
Run
.
2. Click
Continue Run
for each Differences for profile: xxxxx window and then
OK
.
3. If no errors occur, a window similar to the one shown below will be displayed.