VBrick Systems ETHERNETV V4.4.3 - Manual (Page 62)

50 © 2009 VBrick Systems, Inc.
Name Enter a unique, descriptive name that will be displayed on the virtual
remote. For example in Figure 10, "Sony DVD" is the configured
name shown on the controller. No embedded spaces or special
characters are allowed.
Device Select a device from the dropdown list. The list shows serial port
direct-connect devices and VBIR (SpitFire) commanded devices
that are tested and supported by VBrick. It also shows any custom
VBIR devices you have added. Creating User Defined VBIR custom
devices is explained below. You cannot create custom serial port
direct-connect devices. If the source device you wish to control
does not have a serial port, you must use a VBIR for remote control.
Source Select as the source either a VBrick encoder or a Live Video Stream
URL (identified by
URL ) from the dropdown list. The Device that
was selected above will be associated with the specified Source.
Selecting a Live Video Stream URL requires that you specify an IP
address and port. Enter these in the IP and
Port fields that are
displayed when you select a Live Video Stream URL.
User Defined VBIRs Select the SpitFire version you have (SpitFire II or III) and enter a
Description and a three-digit Code (see Add User-Defined VBIRs
below).