Turtle Beach Audio Advantage Amigo TBS-1121-01 - Manual (Page 27)

Audio Advantage Amigo
Page 23
2-speakers (Stereo)
Select this configuration when using powered stereo speakers. The speakers may be
connected to the Headphone – S/PDIF Output.
Using a Headset with Microphone
Insert the headset’s mic jack (sometimes colored pink) into the Mic Input and the line jack
(sometimes colored green) into the Headphone-S/PDIF Output. Set the speaker
configuration in the Control Panel Speakers Tab to Headphones. Adjust the mic level
with the Control Panel Mixer Tab.
The Amigo is a perfect companion for Internet phone or online chat when used with this
headset.
When inserted into the USB port, the Amigo automatically becomes the default headset and
microphone interface, allowing you to listen and speak using the headset and mic. When
you’re done, unplugging the Amigo from the USB port returns your PC or laptop to its
previous audio configuration.
Testing the Speaker Configuration
After selecting the speaker configuration to match your speaker system, you can check if the
speakers are properly connected by clicking on the speaker icon to play a test signal on that
speaker.
The buttons at the bottom of the speaker icon
section, labeled Test and Loop, operate as
follows:
ƒ Test: When this button is clicked, the test
signal automatically advances to the next
speaker so that both speakers play once.
ƒ Loop: When this button is enabled, if the
Test button is clicked, the test signal will
continuously play in sequential order on
both speakers until the Test button is
turned off. If the Loop button is enabled
with the Test button off, clicking a speaker
will repetitively play the test signal on that speaker until the Loop button is turned off.