Vestax PCV-275 - Manual (Page 5)

4
MAX MIN
PHONO 1
LINE 1
LINE 2
PGM 1
INPUT
PRE OFF POST
ON OFF
EFFECT
LEVEL
CUE
SIGNAL
+16dB -16dB
+12dB -12dB
+16dB -16dB
R L
BAL
0
1
2
3
4
5
6
7
8
9
10
HI
MID
LO
EQ
1
2
3
5
6
7
4
1 INPUT SELECTOR
Used to select input (2 line or 1 phono) to be sent to each PGM channel.
2 TRIM CONTROL
Adjusts the Input level of each channel. Set INPUT FADER to 7- 8position. adjust
TRIM so that the INPUT LEVEL METER shows about 0dB.
3 BALANCE CONTROL
Adjusts the stereo balance for each PGM channel. Can be used for adjusting the
unbalanced stereo image caused by a strong anti-skating setting. Clockwise rotation
from center position increases the volume of R over L channel. A counter
clockwise rotation increases the volume of L channel over R.
4 EQUALIZER(HI,MID,LOW)
Adjusts the HI, MID, LOW frequencies for each PGM channel. Each band has
following specifications.
HI 8kHz 16dB
MID 500Hz 12dB
LOW 80Hz 16dB
5 EFFECT SWITCH
This switch enables the signal from each programs to be sent to AUX send jack.
Different signal routes can be selected this switch to different positions.
P R E : The signal before the input fader (after the EQ) will be sent to AUX
output.
POST : The signal after the input and cross fader will be sent to AUX
output.
O F F : No signal will be sent to AUX output.
6 CUE SWITCH
Used to send the signal from each program to monitor section for headphone
monitoring.
7 INPUT FADER
Used to adjust the Input level of each program. Usually set at the 7-8 position. This is
a detachable fader for the ease of replacement. Replace with the IF-175 when it is worn out.
8 CROSS FADER
When the Input level of PGM1 and PGM2 are properly set, PGM1 will be heard with
the cross fader set to the left side. PGM2 will be heard with the cross fader set to the
right side. When the cross fader is set in the center, both programs will be heard. This
is detachable fader for the ease of replacement with "CF-PCV" when it is worn out.
Insert the
multi-cable connector
Set side switch to "PCV" position.
PMC CONNECTOR
Set switch to "PMC" position
CF-PCV For
PMC SERIES
( PMC05ProII, PMC06ProA, etc)
PROGRAM INPUT SECTION