Vestax PCV-275 - Manual (Page 7)

6
MASTER SECTION
15 MASTER OUT LEVEL METER
The LED level meters indicate the signal level of the line out.
16 CUE LEVEL METER
The LED level meters indicate the signal level of PGM input selected by
CUE SWITCH.
17 EFFECT SEND LEVEL
Used to adjust the output level from EFFECT SEND JACK. The signal is
selected by the effect switch.
18 EFFECT RETURN LEVEL
Used to adjust the input level from the EFFECT RETURN JACK. This
EFFECT RETURN can be used as the sub line input.
19 EFFECT CUE SWITCH
Used to send the signal from EFFECT RETURN JACK to the monitor
section for headphone monitoring.
20 MASTER BALANCE VOLUME
Adjusts the signal balance of left to the right side of the outputs from the
OUTPUT jack on the rear panel.
21 MASTER LEVEL VOLUME
Adjust the signal level output from the output jack on the rear panel.
22 SPLIT CUE SWITCH
When this switch is ON, the master signal is always heard through the
right earcup of the headphone. The CUE signal will be heard in the left
earcup when that input is selected by the CUE SWITCH (5, 14). This
enables both programs to be monitored simultaneously,thus assisting in
beat mixing.
23 HEAD PHONE LEVEL
Adjusts the headphone output level.
24 HEAD PHONE JACK
Use this jack to connect the headphones the impedance 8ohm to 600ohm
can be used, 150ohm is recommended.
ON OFF
CUE
EFFECT
MASTER
MONITOR
MAX MIN
SEND
MAX MIN
RETURN
R L
BAL
MAX MIN
LEVEL
SPLIT CUE
PHONES
IN
MAX MIN
ON
OFF
PHONES
LEVEL
+ 8
+ 5
+ 3
+ 1
0
-1
-3
-5
-7
-10
-15
POWER
+ 8
+ 5
+ 3
+ 1
0
-1
-3
-5
-7
-10
-15
POWER
CUE
L R
15
17
20
21
22
23
24
18
19
16
MASTER
ISOLATOR SECTION
25 HI SWITCH
Allows cutting off the sound of treble range. Sound volume will be cut
when the switch is set downwards. When the switch is put back, the output
volume returns to normal. Can be useful for cutting off the sound of the
cymbals or high hats for example.
26 MID SWITCH
Allows cutting off the sound of the middle range. Sound volume will be cut
when the switch is set downward position. When the switch is put back, the
output volume becomes normal sound volume. Can be used for cutting off
vocal and melody from the source.
27 LOW SWITCH
Allows cutting off the sound of the bass range. Sound volume will be cut
when the switch is set downward. When the switch is put back, the output
volume return to normal. Can be utilized for creating the effects of an
acapella.
27 26 25
PGM1 ISOLATOR
LO MID HI