VTech i 6773 - Manual (Page 9)

6
Getting Started
Connecting Power to Base Unit
CAUTION: Use only the VTech power supply provided with your telephone.
Plug the power adapter into an electrical outlet not controlled by a wall switch, and
the connector into the bottom of the base unit.
Setup
Installation of Battery
1. Remove battery compartment cover by
pressing on the indentation and sliding
downward.
2. Align the two holes in the plug with the
socket pins, then snap the plug into place.
Place the battery in the compartment with
the wires in the upper right corner.
3. Replace the battery cover by sliding it
upwards.
4. If the new battery is not already charged,
place the handset in its base or charger
and allow it to charge for 10-12 hours.
After the initial charge, a maintenance
charge of 10 hours should be sufficient.
Be sure to place the handset in its base
when not in use to insure maximum daily
performance.
To power outlet To telephone outlet