VBrick Systems EtherneTV-NXG 2 - Manual (Page 4)

V B R I C K E T H E R N E T - N X G V O D Q U I C K S T A R T G U I D E V E R S I O N 2 . 0 . 0 E
C O P Y R I G H T V B R I C K S Y S T E M S P A G E 4 J U N E 2 3 , 2 0 0 4
Quick Start
1. Unpack the EtherneTV-NXG1 Server.
Each shipment comes with:
• An introduction letter
• Quick Start Guide and Release Notes (located on CD-ROM 8250-0002-0000)
• (1)
EtherneTV-NXG system
• Power cord
• Rack mount kit (Kit type must be specified)
• Recovery CDs and a floppy disk that contains the NXG license (do not lose)
NOTE: The server comes preloaded with the Operating System and VOD application
software. After the system is powered, a kick-start wizard will guide you through the initial
setup for permanent operation.
Before you Begin
Make sure that there is:
• A separate PC running Internet Explorer
• PS/2
mouse
• Keyboard
• Monitor or console
NOTE: If you have purchased an external storage device such as a SCSI attached DAS
it must be connected prior to powering up the NXG system.
Please obtain the following information for the EtherneTV-NXG before applying power to the
unit:
NOTE: Unix commands are case sensitive and should be entered as shown.
INFORMATION REQUIRED Answer Example
Hostname (that will be assigned to EtherneTV
VOD) vbvodnxg
EtherneTV VOD IP address 172.17.6.55
Default gateway (router) 172.17.1.5
System network netmask 255.255.0.0
Broadcast IP address 172.17.255.255
Default network IP address 172.17.0.0
Domain name vb.loc
DNS IP address 64.80.0.162
EtherneTV VOD serial number (from back of unit) unused at this time
Server name (Not Applicable) unused?
TABLE 1