VBrick Systems EtherneTV-NXG 2 - Manual (Page 7)

V B R I C K E T H E R N E T - N X G V O D Q U I C K S T A R T G U I D E V E R S I O N 2 . 0 . 0 E
C O P Y R I G H T V B R I C K S Y S T E M S P A G E 7 J U N E 2 3 , 2 0 0 4
Make required entries:
Enter the system’s new hostname in lowercase:
• Enter the name of the host and Enter <cr>
• Type “y” and and Enter <cr> to continue
Enter the system’s new IP address:
• At the prompt, enter the IP address of the EtherneTV-NXG server and Enter <cr>
• Type “y” and and Enter <cr> to continue
Enter the system’s new default route (gateway) ip-address:
• At the prompt, enter the IP address of the default router and Enter <cr>
• Type “y” and and Enter <cr> to continue
Enter the system’s new network netmask:
• At the prompt, enter the network mask and Enter <cr>
• Type “y” and and Enter <cr> to continue
Enter system’s new broadcast ip-address:
• At the prompt, enter the broadcast IP address and Enter <cr>
• Type “y” and and Enter <cr> to continue
Enter the system’s new default network ip-address:
• At the prompt, enter the default network IP address and Enter <cr>
• Type “y” and and Enter <cr> to continue
Enter the system’s new domain for the server:
• At the prompt, enter the server’s domain name and Enter <cr>
• Type “y” and and Enter <cr> to continue
Enter the system’s new DNS IP address:
• At the prompt, enter the DNS server’s IP address and Enter <cr>
• Type “y” and and Enter <cr> to continue
NOTE: Unix commands are all lower case and can contain no spaces. Use an
underscore _ for separation. Use the values you determined in Table 1.