VBrick Systems EtherneTV-NXG 2 - Manual (Page 8)

V B R I C K E T H E R N E T - N X G V O D Q U I C K S T A R T G U I D E V E R S I O N 2 . 0 . 0 E
C O P Y R I G H T V B R I C K S Y S T E M S P A G E 8 J U N E 2 3 , 2 0 0 4
At the login prompt, type “root” then press Enter.
At the password prompt, type “omnibase” then press Enter.
Verify entries
The previous entries will be displayed.
• Review the information you entered. If everything appears to be correct, type “y” and
Enter to continue. Otherwise, type “n” and repeat the setup process.
• The EtherneTV-NXG server displays the configuration files it will update. Type “y”
then press Enter to continue. The changes will be displayed for each of the
following files. Review each, type “y” to accept, then press Enter to continue.
o /etc/sysconfig/network
o /etc/sysconfig/network-scripts
o /etc/resolve.conf
o ServerName in httpd.conf
• When asked if you have completed reviewing the files to be updated, type “y” then
press Enter to continue.
• Wait several minutes for setup to complete. A message will be displayed:
• Press Enter
• Enter the login and password when prompted:
• NOTE: If you encounter an error during set-up or if the server is moved to
another network you MUST perform the following operation:
4. Verify EtherneTV-NXG Server Operation
Verify that there is an amber link light on the EtherneTV-NXG server’s Ethernet port.
• From the Linux Administrator command line: Ping the local gateway IP address.
Example: ping 172.17.1.5 (use your appropriate local gateway IP address)
• From a separate PC: Ping the EtherneTV-NXG server from a PC using the
EtherneTV-NXG1 IP address.
Example: ping 172.17.6.55 (use the IP address of your EtherneTV-NXG server)
Done
Omnibase setup is complete; press enter to continue to login
Rename the setup file as follows:
root# mv /opt/vbricksetup/.vbrickmbase_is_setup
/opt/vbricksetup/.vbrickmbase_is_not_setup
Reboot the server
root# reboot