Valor Auto Companion Inc. 739DVN - Manual (Page 19)

19
Log Installation
13.1 Ceramic Logs Installation
Install the Rear Log Rest supplied using 3 screws provided. See fi gure 13.1.
Place the Ash Bed in position. The projections at the front of the Ash Bed are positioned against the
sloping metal stops, immediately behind the burner. See fi gures 13.2, 13.8, 13.9.
Place the Rear Log in position. Place the Log on the 2 pins on the top left and right of the Ash Bed. See
fi gure 13.3.
Place the Front Log at the front of the fi rebox locating it on the front support. See fi gure 13.4.
Place the Left Side Center Log in position, locating the thick part on the left side of the Ash Bed on the 2
pins provided, with its “nose” resting on top of the Ash Bed center projection. See fi gure 13.5.
Identify the Right Side Center ‘Y’ log. Place the Right Side Center Y Log in position, locating the thick
part on the right side of the Ash Bed on to the pin provided with its “nose” located on the single pin. See
fi gure 13.6.
Install the Cross Twig by fi rst mounting the rear of the Cross Twig on the pin situated on the top of the
Rear Log near the center. Then, move the front of the Cross Twig until it fi nds its location in the cradle
provided in the Front Log. See fi gure 13.7.
1.
2.
3.
4.
5.
6.
7.