Vertex Standard HX760S - Manual (Page 33)

Page 33 HX760S
e
c
f
h
d
g
10. Press PTT switch of the HX760S to exit the HX760S to normal operation.
11. Turns both BH-2 and HX760S off.
7.2 CONTROLS AND SWITCHES
i
j
c Microphone
d LED Indicator
Blinking Blue: The BH-2 is correctly recognized by the HX760S.
Blinking Red: The BH-2 is not correctly recognized by the HX760S.
LED color is Red and Blue: The battery voltage of the BH-2 is Low.
e POWER( ) Switch
Turns the BH-2 on and off.
To turn the BH-2 on, press and hold this switch until the BH-2’s LED indi-
cator glows red, and the beeper sounds a high pitch tone (approximately
three seconds).
To turn the BH-2 off, press and hold this switch until the beeper sounds
two brief tones (emit the one low pitch tone and then one high pitch tone),
and the BH-2’s LED indicator glows red (approximately five seconds).
f VOLUME (–) Switch
Pressing this switch decrease the receiver volume level.
Secondary use:
Press this switch while pressing and holding the PTT switch, to decreases
the microphone gain of the BH-2.