Vanguard Managed Solutions 3400 Series - Manual (Page 58)

4-2 Powering Up Your Vanguard 3400 Series
Power Up Procedure
Power Up Procedure
Introduction This section explains how to power up the Vanguard 3400 Series.
Procedure Follow these steps to power up your Vanguard 3400 Series.
To power down the Vanguard 3400 Series, unplug the power supply AC power cord
from the power receptacle.
LEDs Figure 4-1 shows the Vanguard 3400 Series LEDs and the table that follows
describes them.
Figure 4-1. Vanguard 3400 Series LEDs
Step Action
1 Ensure that all the cards are fully inserted and secure.
2 Ensure that the AC power cord is plugged in.
3 Ensure the front panel power LED is on.
Power Stats
LED Description
3400 Series System State
Initial
PowerON
Diagnostics
Executing
SW Loading Operational
Status
Power Power OK On On On On
Stats Diagnostics/SW
Loading
On Off Blinking On