Vinotemp VT-45 - Manual (Page 10)

9 1 7 6 3 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
REVERSAL OF DOOR SWING
The door of the wine cellar could be opened either from the left or right side.
The wine cellar, as delivered to you, is installed from the left side.
If you want to reverse the open direction of door, please do as follows:
1. Disconnect the power, take out all the wines and lay the wine cellar
back on the ground. Please remember when finished reversing the
door not to power up the unit for 24 hours to allow the coolants to
settle in the compressor.
2. Remove top hinge cover. Use the special screw driver to remove the
three screws on the top hinge, then lift up the door to take the door off.
3. Unscrew the two screws and remove the grill.
4. Remove the support wheel on the left bracket.
5. Use the special screw driver to unscrew the six screws on the right
downward door axis and left bracket. Remove the support wheel on
the left bracket and install it on the right bracket.
6. Install the right bracket and left downward door axis.
7. Remove the fixing screw on the door handle, then remove the handle
and fix it on the right of the door.
8. Reinstall the door.
9. Install the top hinge on the other side.
10.Screw back in place the top hinge cover, grill and screw covers.
11.Install the support wheel on the right bracket.
12.You now have the door fully installed on your desired side.