Vinotemp VT-45 - Manual (Page 7)

CORD INSTRUCTIONS
For your protection, this unit is equipped with a
3-conductor cord set that has a molded 3-prong
grounding-type plug, and should be used in
combination with a properly connected
grounding-type outlet as shown in figure A.
OPERATING INSTRUCTIONS
1. Place your wine cellar on a flat surface that is strong enough to
support the unit when fully loaded.
2. This wine cellar is designed to be built-in (fully recessed) or free
standing.
3. Do not place heavy objects on top of the unit.
4. Do not place the unit in a moist place or display in direct sunlight.
5. Do not place the unit next to a major appliance that emits large
amounts of heat, such as a dishwasher, microwave, toaster oven,
oven or barbecue, etc.
6. Do not plug unit into the same outlet as a refrigerator or microwave.
7. The unit’s cooling system operates efficiently with an ambient
temperature of less than 90°F (32°C). Do not install in a garage or
basement.
8. Gently place/slide the racks in the wine cellar.
9. Determine the best setting to use: refer to the temperature guides
for appropriate serving (see pages 8). An easy reference guide for
serving temperatures is also found on the inside door.
10. Place bottles inside the cooler.
11. Plug the power cord into a standard electrical outlet.
Important: When using the wine cellar for the first time, allow at
least 24 hours for the internal temperature to adjust properly, Make
sure there are at least 3 to 5 bottles in the unit.
ALWAYS REMOVE ALL BOTTLES BEFORE MOVING THE WINE CELLAR
6
W W W . V I N O T E M P . C O M