Vinotemp VT-45 - Manual (Page 12)

11 1 7 6 3 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSE
Vibrations • Check to make sure the wine cellar is on a level surface.
The door will not
close properly.
• The wine cellar is not on a level surface.
• The racks are out of position.
• The bottle is too long.
Fan is always
running. • This is simply a function of the cooling system. The lower
the setting, the more the fan will run. If the room is
warmer than 90°F(32°C), it will run more.
• The unit has been designed to run continuously when
operation at the lower temperatures.
Unit has no
power. • Check the wall outlet for power. Make sure the outlet is not
controlled by a wall switch.
The inside
temperature
does not seem
correct.
• Make sure the cooling vents are not obstructed.
• The room may be too hot. If the ambient temperature is
90°F(32°C) or higher, the unit can have difficulty chilling
adequately on the white wine setting.
• When using the unit for the first time, it can take up to 24
hours to reach the desired temperature.
The unit does
not operate.
• It may not be plugged into the wall socket.
• Make sure the wall socket it functional by testing another
electrical appliance in the power socket.
Power is ON but
the unit will not
cool.
• Make sure there are at least 3 to 5 bottles in the unit. Allow
at least 24 hours for the internal temperature to adjust.
• If the room temperature is above 90°F(32°C), the unit can
have difficulty cooling. Humidity does not affect the cooling
ability of the unit.
• To achieve accurate temperature control, the unit should
not be used of operated in any of the following locations:
o In a sunny place
o In a room with poor air circulation such as a garage near
another heat-producing appliance such as a dishwasher,
oven or refrigerator.
o With an outlet shared with a refrigerator, as the
refrigerator will drain power from the wine cellar.
o In a cabinet or closet.
• Make sure the cooling vents are not obstructed.
• If the lower compartment does not cool, check if the fan on
the middle board is not running.