Operating instructions, Temperature control – Vinotemp VT-38 User Manual
Page 9
9
9
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
OPERATING INSTRUCTIONS
o
Plug the power cord into a standard electrical outlet.
o
Gently place/slide the racks in the cooler.
o
Determine the best temperature setting to use.
o
Place bottles inside the cooler.
o
Limit the frequency of opening the door to conserve energy and
maintain proper storage temperature.
Important: When using the cooler for the first time, allow at least 24
hours for the internal temperature to adjust properly. Make sure there are
at least 3 to 5 bottles in the unit.
TEMPERATURE CONTROL
Important note: In order to operate efficiently, unit should be in
an environment with an ambient temperature of less than 90°F
(32°C).
Temperature Presets:
For your convenience, the cooler is programmed at storing temperature.
The
temperature zone for the right side pre-set by the manufacturer is
54
o
F (12
o
C). The temperature zone for the left side pre-set by the
manufacturer is 45
o
F (7
o
C).
Setting the temperature control (manually):
You can manually adjust the temperature. Simply press the button on
the control panel to decrease the temperature and the button to
increase the temperature inside the cooler in 1° increments. The
temperature zone for the right side ranges from 48
o
F to 65
o
F (9
o
C
-18
o
C).
The temperature zone on the left side ranges from 40
o
F to 65
o
F (4
o
C
-
18
o
C). The variance between compartments can be no more than 18
o
F
(10
o
C).
When the cabinet temperature is too low the LED will display “LL”. When
the temperature is too high it will display “HH”. The “ER” display shows
when there has been a power disruption.
Both sides of this unit can store wine or beverages, but the left side can
be set colder than the right side.