Appendix, Troubleshooting – VTech DS221-2 User Manual

Page 49

Advertising
background image

45

Appendix

Troubleshooting

The messages on the answering system are very difficult to hear.

Press

VOL on the telephone base or handset to increase the speaker volume.

on the telephone base or handset to increase the speaker volume.

The answering system does not record messages.

Make sure the answering system is on.
When the answering machine memory is full, it does not record new messages until

some old messages are deleted.

The messages on the answering system are incomplete.

If a caller leaves a very long message, part of it might be lost when the answering

system disconnects the call after four minutes.
If the memory on the answering system becomes full during a message, the

answering system stops recording and disconnects the call.
If the caller’s voice is very soft, the answering system might stop recording and

disconnect the call.

The answering system does not respond to remote commands.

Make sure your remote code is correct (page 11).
Make sure you are calling from a touch-tone telephone. When dialing a number,

there should be tones. If there are clicks, then it is not a touch-tone telephone and

cannot activate the answering system.
The answering system might not detect the remote access code when your

announcement is playing. Wait until the announcement is over before entering

the code.
There might be interference on the telephone line you are using. Press the dial pad

keys firmly when dialing.

Common cures for electronic equipment.

If the telephone is not responding normally, put the cordless handset in the

telephone base. If it does not respond, try the following (in the order listed):
Disconnect the power to the telephone base.
Disconnect the battery on the cordless handset.
Wait a few minutes before connecting power to the telephone base.
Re-install the battery and place the cordless handset in the telephone base

or charger.
Wait for the cordless handset to synchronize with the telephone base. Allow up to

one minute for this to take place.






Advertising
This manual is related to the following products: