Volvo V70R - Manual (Page 54)

53
Instruments and controls
Trip computer
Controls
To access the trip computer information, you
must turn the ring (B) in steps, either forward
or backward. By turning again, you return to
the starting point.
NOTE!
If a warning message interrupts while
you are using the trip computer, you must first
acknowledge the message by pressing the
READ button (A) to return to the trip
computer.
Functions
The trip computer displays the following
information:
• AVERAGE SPEED
• SPEED IN MILES PER HOUR
1
• CURRENT CONSUMPTION
• AVERAGE CONSUMPTION
• KILOMETRES TO EMPTY TANK
• STC/DSTC, see page 126
Average speed
The average speed since the last reset
(RESET). When the ignition is switched off,
the average speed is stored and used as the
basis of the new value when you continue
driving. This can be reset with the RESET
button (C) on the lever.
Speed in miles per hour 1
Current speed is displayed in mph.
Current consumption
Continuous information on current fuel
consumption, calculated each second. The
figure in the display is updated every couple
of seconds. When the car is stationary, "----"
is shown in the display.
NOTE!
There may be a slight error in the
reading if a fuel-driven heater is used.
Average consumption
The average fuel consumption since the last
reset (RESET). The average fuel
consumption is stored when the ignition is
switched off and remains until reset with the
RESET button (C) on the lever.
NOTE!
There may be a slight error in the
reading if a fuel-driven heater is used.
Kilometres to empty tank
The range to empty is calculated based on
the average fuel consumption over the last
30 km. When the range to empty is shorter
than 20 km then "----" is shown in the display.
NOTE!
There may be a slight error in the
reading if fuel consumption is changed due to
a change in driving style or if a fuel-driven
heater is used for example.
1. Certain countries