Worth Data P11/12 - Manual (Page 16)

2-10
See the previous page's "emulating special keys in the preamble" section.
A final use of the Preamble/Postamble is to enter a minimum/maximum length
check for bar code data read. Use the Preamble or Postamble by entering |nnmm
where "|" is ASCII 124, "nn" is the two digit minimum to be read and "mm" is
the two digit maximum to be read.
Data Transmission Timing
None 0
Short 1
Short Medium 2
Medium 3
Long 4
Timing does not apply to Mac ADB or any USB attachment.
Before trying this, try the "learned timing" discussed on page 12.
For Computer Interfaces 0,1,and 2, the WDP Reader can transmit bar code data at
five different rates. Most computers work at the fastest speed ("None"), but some
systems require slower rates. Try the "None" setting, and (when you're done
configuring it) try reading some codes. If you get partial or garbled reads, try other
timing settings to solve the problem. (The Mac needs no timing adjustments.) Try
each timing rate (fast to slow); don't assume that if the slowest and fastest don't
work, the intermediate settings won't either. After each failing attempt at timing
setting, type "12" in the upper keyboard row to be sure the keyboard has not been
locked or confused; if the "12" doesn't type correctly, reboot before trying a new
timing setting.
Reset
Don't scan Reset unless you're sure you want to restore the WDP Reader to its
default settings (as described on page 7), erasing all changes you've made, because
that's exactly what Reset will do.
MagStripe
None (or triggered Integrated CCD) 0
Track 1 (or triggerless Integrated CCD) 1
Track 2 2
Track 3 3
Dual Track Scanner,Output both only 4
Dual Track Scanner,Output both or 2 only 5
Track 1 or 3 Only on Dual Track Scanner 6
Track 2 only output on Dual Track Scanner 7
Track 1&2&3 Scanner, all 3 or 1&2 only 8
Track 1&2&3 Scanner, all 3 or 1 only 9
Caps Lock Off (just for MagStripe) E
Caps Lock On (upper case alpha for mag) F