Water Boss Series 255 - Manual (Page 11)

11
Table 3 - Programming Parameters
Parameter
Name Description
Range of
Values
Minimum
Increments
Default
Units of
Measure
Notes
P6
Refill
controller
1 to 99 1 33
Enter the value molded into
the end of the refill controller.
P7
Brine draw
value
1 to 99 1 25
Select number from Table 4
and enter that number.
P8 Not used NA NA NA NA NA
P9
Backwash
time
3 to 30 1 14 Minutes
Skip this parameter to accept
the default or enter a value.
P10
Slow rinse
time
8 to 125 1 40 Minutes
Skip this parameter to accept
the default or enter a value.
P11
Fast rinse
time
2 to 19 1 4 Minutes
Skip this parameter to accept
the default or enter a value.
P12
Units of
Mmeasure
0 to 1 1 0
0 = U.S., 1 = Metric. Skip this
parameter to accept U.S. or
enter 1 for Metric.
P13 Clock mode 0 to 1 1 0
0 = 12-hour clock.
1 = 24-hour clock. Skip this
parameter for a 12-hour clock
or enter 1 for a 24-hour clock.
P14
Calendar
override
0 to 30 1 0 Days
0 = no calendar override. Skip
this parameter for no calendar
override or enter a value.
P15 Reserve type 0 to 3 1 0
0 = variable reserve, 1 = fixed
reserve, 2 = variable reserve
with immediate regen,
3 = fixed reserve with
immediate regen. Skip this
parameter to accept the
default or enter a different
reserve type.
P16
Fixed reserve
capacity or
initial average
value
0 to 70 1 30
Percent of
capacity
Description depends on the
value entered for P15. Skip
this parameter to accept the
default or enter a different
value.
P17
Operation
type
0 to 1 1 0
0 = 5-cycle counter or co-
current conditioner, 1 =
reserved for future use.
P18
Salt/capacity
change
Lockout
0 to 1 1 0
0 = none, 1 = salt/capacity
change locked out. Skip this
parameter to accept the
default or enter 1 to lock out
salt/capacity change.
P19
Factory
defaults
0 to 3 1 9
Loads in a set of default
values. Refer to the Special
Notes for Level II
Parameters section in this
manual.