Whistler GPS - Manual (Page 13)

Compact Flash Card
The Galileo ™ uses standard Type II Compact Flash
(CF) Memory Cards. These cards can be added to the
Galileo
™ GPS receivers through the battery compartment.
CF cards come in many configurations up to 1024 MB.
The addition of a CF card to the unit allows data to be
uploaded/download to/from the Whistler Map
™
Software CD (provided with the Galileo ™ Accessory Upgrade
Pack and Galileo Elite ™ ).
Important: Make sure that the CF card you purchased
(other than from Whistler) has the CF and FCC logo’s
clearly visible.
Add or Remove the CF card:
1. Press and hold the power button to turn the unit off.
2. Remove the battery door.
3. Remove both of the AA batteries.
4. To remove the CF card, gently pull the CF card
slightly towards the top of the unit. Carefully continue
to slide the CF card out of the channel it’s in. Tilt the
Galileo
™ to help remove the CF card.
5. To install the CF card, hold it such that the tiny holes
are at one end facing the bottom of the unit and the lip
is on the top. Place the CF card in the channel
provided in the battery compartment.
Note: CF card can only go in one way. Carefully push
the CF card towards the bottom of the unit until you
feel it lock into place. Do not force the CF card. Forcing
the CF card could cause damage to the card and/or
the unit.
6. Reinstall the batteries into the battery compartment.
Be sure to observe the proper polarity.
7. Replace the battery compartment door.
8. Press and hold the Power (PWR) button to turn on the
Galileo ™ .
Compact
Flash Card
Add or
Remove the
Compact
Flash Card
GALILEO ™ GPS
11
Compact Flash Card (CF)