Wizcom Quicktionary 2 - Manual (Page 6)

Getting Started
6
Learning to Scan (using the Trainer)
This tutorial uses the Quicktionary application and the
plastic scanning Trainer provided with your Pen.
1. Slide the Trainer onto the tip of the Pen (instead of the
cap) and press into place.
2. Turn the Pen on. The Select Dictionary menu will
appear. Select the English Æ German dictionary.
3. The Input Screen will appear with the message “Scan
in English”. The red light flashing at the tip of the Pen
indicates that the Pen is ready to scan.
4. Position the Pen at a 90° angle and center the following
text between the feet of the trainer. This angle should
be maintained even when scanning without the trainer.
Use the following practice sentence:
This sentence will help me practice scanning.
5. Glide the Pen from right to left in a straight line over the
text. Start scanning 1cm from the end of the text and
finish 1cm after the beginning of the text.
6. The Split Screen will appear, with the scanned text on
the screen. If the text does not appear correctly on the
screen, scan again and the text on screen will be over-
written by the new text.