Welch Allyn 2380 - Manual (Page 12)

SCANCODE
SCANTEAM 2380 Information and Examples
SELECTION
When “main keyboard numbers” is selected, numbers will be sent to the host terminal as if
keyed in from the main keyboard. If “numeric keypad” is enabled, numbers will be sent as if
keyed in from the numeric keypad.
When programmed on, beeps the PC on a good read.
Reconfigures the 2380 to use K2 (SCANTEAM 2300) compatible scancodes. If other Welch
Allyn wedge products are being used or are planned for future use, it is strongly
recommended to program this selection for “YES” and use the function codes found in the
Keyboard Function Codes Table 2 and Table 3 in the Appendix A.8 of the 2380Technical
Manual. Otherwise, the 2380 will be programmed to use function codes in Keyboard
Function Codes Table 1 in the Appendix A.8 of the 2380 Technical Manual.
Occasionally, keyboard activity before a bar code is scanned will cause the wand to beep
intermittently or turn off. This selection will prevent this from happening.
If the SCANTEAM 2380 has been downloaded to contain another scancode table,
programming this selection to “YES” will cause the new scancode table to be used, rather
than the normal scancode table. This menu selection is applicable for use with terminals not
equipped with standard manufacturers’ keyboards (that is, foreign keyboards).
K2 SCANCODE CAPABILITY
NEW KEYBOARD SCANCODE TABLE
BEEP PC
NUMERIC KEYPAD
RX INTERRUPT
12